Water-based, rust-resistant enamel, providing high protection against corrosion. 3-in-1: rust convertor, primer and finishing enamel. Saves time and layers as it doesn’t require a primer and dries faster than traditional synthetic enamels. High-quality, long-lasting decorative enamel. Smooth satin finish.
Characteristics:
- Indoor/ Outdoor use
- Ideal for application directly over rust on iron or oxidized steel
- Fast drying
- Does not require primer
- Great adhesion
- UV resistant, Non Fading
- Water resistant, washable, highly resistant
- Certified by UNE EN ISO 9227:17 for anticorrosive capacity in saline mist
How to Use:
- Apply to a clean and dry surface, removing dirt with degreasers or detergents and clean water.
- If there are areas of corrosion, remove loose rust and scale with wire brushes or sanding paper.
- Stir the product until it is perfectly homogeneous.
- Do not apply the product in extreme temperatures or on surfaces exposed to strong sunlight.
- Maintain good ventilation conditions during the drying time.
- Do not apply in relative humidity conditions exceeding 80%.
- Drying, performance, and other properties may vary depending on climate and application variations.
- It is recommended to apply a minimum of two coats at 50-60 dry microns (8 m2/l per coat). For adverse conditions, this thickness should be increased to 150-180 microns.
- Apply by roller, brush or spray gun
Coverage: 10 m²/Lt
Drying time: 1h
Recoating time: 12-24h
Dilution Level:
- Gun: 5-15% with Monto Solvent
- Brush 0-10% with Monto Solvent
